We estimate the Stokes wave starting power for stimulated thermal Rayleigh scattering (STRS) produced by thermal fluctuations in the fiber core that transiently alter the refractive index profile in the core. A transverse temperature gradient creates a transverse refractive index gradient via the thermo optic effect, and if the fluctuation frequency lies in the STRS gain band, it can couple light from mode LP$_{01}$ to LP$_{11}$ to seed STRS. This spontaneous Rayleigh seed may be stronger than the quantum background and may affect the mode instability thresholds of fiber amplifiers. This new seed estimate can be incorporated in STRS models to improve threshold calculations.
We present a passively mode-locked, tunable soliton Ho:fiber ring oscillator, optimized for seeding of Ho:YLF amplifiers. The oscillator is independently tunable in central wavelength and spectral width from 2040 nm to 2070 nm and from 5 nm to 10 nm, respectively. At all settings the pulse energy within the soliton is around 800 pJ. The soliton oscillator was optimized to fully meets the spectral requirements for seeding Ho:YLF amplifiers. Its Kelly sidebands are located outside the amplifier gain spectrum, resulting in a train of about 1 ps long pedestal-free pulses with relative intensity no…
Using a numerical model we study the frequency dependence of mode coupling gain due to stimulated thermal Rayleigh scattering in step index, Yb doped, fiber amplifiers. The frequency at the gain peak is shown to vary with core size, doping size, population saturation, thermal lensing, fiber coiling, direction of pumping, photodarkening, and pump noise spectra. The predicted frequencies are compared with measured values whenever possible.
Recently, S. Mitryukovskiy et al. presented experimental evidence showing that backward stimulated radiation at 337 nm can be obtained from plasma filaments in nitrogen gas pumped by circularly polarized 800 nm femtosecond pulses (Opt. Express, 22, 12750 (2014)). Here, we report that this backward stimulated radiation is enhanced by a factor of ~ 16 in the presence of a seed pulse. This enhanced stimulated radiation can be either linearly or circularly polarized, dictated by the seeding pulse, which is distinct from the non-polarized nature of the ASE without seeding pulse. We also measured th…
We show by numerical modeling that saturation of the population inversion reduces the stimulated thermal Rayleigh gain relative to the laser gain in large mode area fiber amplifiers. We show how to exploit this effect to raise mode instability thresholds by a substantial factor. We also demonstrate that when suppression of stimulated Brillouin scattering and the population saturation effect are both taken into account, counter-pumped amplifiers have higher mode instability thresholds than co-pumped amplifiers for fully Yb$^{3+}$ doped cores, and confined doping can further raise the thresholds…
We study the process of seeded, or stimulated, third-order parametric down-conversion, as an extension of our previous work on spontaneous parametric downconversion (TOSPDC). We present general expressions for the spectra and throughputs expected for the cases where the seed field or fields overlap either only one or two of the TOSPDC modes, and also allow for both pump and seed to be either monochromatic or pulsed. We present a numerical study for a particular source design, showing that doubly-overlapped seeding can lead to a considerably greater generated flux as compared with singly-overla…
Dependence of mode instabilities (MI) on ytterbium dopant concentrations in high power fiber amplifiers has been investigated. It is theoretically shown that, by only varying the fiber length to maintain the same total small-signal pump absorption, the MI threshold is independent of dopant concentration. MI thresholds of gain fibers with ytterbium dopant concentration of 5.93X10^25/m3 and 1.02X10^26/m3 have been measured, which exhibit similar thresholds and agree with theoretical results. The result indicates that heavy doping of active fiber can be adopted to suppress nonlinear effects witho…
We show how signal linewidth affects the gain of stimulated thermal Rayleigh scattering (STRS) which is responsible for mode instability in fiber amplifiers. The gain is reduced if the coherence time of the signal is less than the group velocity induced walk off between modes LP$_{01}$ and LP$_{11}$. We derive equations for short pulses, linear chirps, and general periodic cases.
We show by detailed numerical modeling that stimulated thermal Rayleigh scattering can account for the modal instability observed in high power fiber amplifiers. Our model illustrates how the instability threshold power can be maximized by eliminating amplitude and phase modulation of the signal seed and the pump, and by careful launch of the signal seed. We also illustrate the influence of photodarkening and mode specific loss on the threshold.
We demonstrate stimulated Raman gain using a broadband LED Stokes source to measure vibrational spectra of aqueous glucose solutions. This versatile and cost-effective method increases Raman signal for a variety of applications. We measured both stimulated Raman and spontaneous Raman spectra of glucose solutions with concentrations up to 10 mM with a photon counter and lock-in amplifier. We built partial least squares regression models based on both stimulated Raman and spontaneous Raman spectral data measured with each instrument for predicting concentrations of the glucose solutions. The sti…
We use a detailed numerical model of stimulated thermal Rayleigh scattering to compute mode instability thresholds in Tm$^{3+}$-doped fiber amplifiers. The fiber amplifies 2040 nm light using a 790 nm pump. The cross-relaxation process is strong, permitting power efficiencies of 60%. The predicted instability thresholds are compared with those in similar Yb$^{3+}$-doped fiber amplifiers with 976 nm pump and 1060 nm signal, and are found to be higher, even though the heat load is much higher in Tm-doped amplifiers. The higher threshold in the Tm-doped fiber is attributed to its longer signal wa…
Phase and/or intensity modulation techniques to broaden the Linewidth of an optical source are well known methods to suppress stimulated Brillouin scattering (SBS) in optical fibers. A common technique used to achieve significant bandwidth enhancement in a simple fashion is to phase modulate with a filtered noise source. We will demonstrate here that, in this case the stochastic nature of noise requires an inclusion of length dependent corrections to the SBS threshold enhancement. This effect becomes particularly significant for short fiber lengths common to most high power fiber amplifiers.
We present a new scheme for a laser cooled Raman optical fiber amplifier. The heat generated in the process of stimulated Raman scattering is compensated for with laser cooling provided by anti-Stokes fluorescence of ytterbium ions doped in the core of the fiber. The device is pumped with two pump sources. One of the pump sources provides Raman amplification of the signal and does not interact with the ytterbium ions in the core of the fiber. The second pump provides laser cooling of the fiber with anti-Stokes fluorescence of the Yb3+ ions. The proper arrangement of Yb3+distribution can provid…
We use a semi-analytical model of stimulated thermal Rayleigh scattering to present theoretical study of seed power on mode instability with the presence of photodarkening. The behavior of mode instabilities as a function of seed power has been investigated. The nonlinear dependence of the threshold with lower seed powers is ascribed to the influence of gain saturation while the reduction behavior of the threshold with higher seed powers is put down to the effects of photodarkening, which agrees well with the experimental results.
We investigate for the first time the enhancement of the stimulated Raman scattering in slow-light Silicon-on-Insulator (SOI) photonic crystal line defect waveguides. By applying the Bloch-Floquet formalism to the guided modes in a planar photonic crystal, we develop a formalism that relates the intensity of the down-shifted Stokes signal to the pump intensity and the modal group velocities. The formalism is then applied to two prospective schemes for enhanced stimulated Raman generation in slow-light photonic crystal waveguides. The results demonstrate a maximum factor of 10^4 (66,000) enhanc…
By focusing on a typical emitting wavelength of 1120 nm as an example, we present the first demonstration of a high-efficiency, narrow-linewidth kilowatt-level all-fiber amplifier based on hybrid ytterbium-Raman (Yb-Raman) gains. Notably, two temporally stable, phase-modulated single-frequency lasers operating at 1064 nm and 1120nm, respectively, were applied in the fiber amplifier, to alleviate the spectral broadening of the 1120 signal laser and suppress the stimulated Brillouin scattering (SBS) effect simultaneously. Over 1 kW narrow-linewidth 1120 nm signal laser was obtained with a slope …
Phase-locking of large mode area Yb photonic crystal fiber amplifiers via stimulated Brillouin scattering phase conjugation is analyzed. The wavefront reversing mirrors are proposed for chirped pulse fiber laser networks. The chirp control via both nonresonant Kerr and resonant index is considered.
We experimentally investigate the evolution of the direct detection noise figure of a non degenerate phase sensitive amplifier based on nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits to investigate the full range of phase sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections.
We study the transverse mode instability (TMI) in the limit where a single higher-order mode (HOM) is present. We demonstrate that when the beat length between the fundamental mode and the HOM is small compared to the length scales on which the pump amplitude and the optical mode amplitudes vary, TMI is a three-wave mixing process in which the two optical modes beat with the phase-matched component of the index of refraction that is induced by the thermal grating. This limit is the usual limit in applications, and in this limit TMI is identified as a stimulated thermal Rayleigh scattering (STR…
The ability to amplify light within silicon waveguides is central to the development of high-performance silicon photonic device technologies. To this end, the large optical nonlinearities made possible through stimulated Brillouin scattering offer a promising avenue for power-efficient all-silicon amplifiers, with recent demonstrations producing several dB of net amplification. However, scaling the degree of amplification to technologically compelling levels (>10 dB), necessary for everything from filtering to small signal detection, remains an important goal. Here, we significantly enhance t…
We report on the generation of broadband, high-energy femtosecond pulses centered at 1.28 um by stimulated Raman scattering in pressurized hydrogen cell. Stimulated Raman scattering is performed by two chirped and delayed pulses originating from a multi-mJ Ti:Sapphire amplifier. The Stokes pulse carries energy of 4.4 mJ and is recompressed down to 66 fs by reflective grating pair. We characterized the short-wavelength mid-infrared source in view of energy stability, beam profile and conversion efficiency at a repetition rate of 100 Hz and 10 Hz. The demonstrated laser will benefit intense THz …
We develop a high-power narrow-linewidth fiber amplifier based on a tapered Yb-doped fiber. In the experiment, the narrow end of the tapered fiber is used as the input port of both pump source and signal light to form a robust all-fiber configuration. The stimulated Brillouin scattering (SBS) is effectively suppressed owing to its gradually increased mode area as well as continuously changed Brillouin frequency shift dependent on the core diameter. As a result, an output power of 260 W without SBS and mode instability (MI) is obtained, with a slope efficiency of 71.3 % and a narrow linewidth o…
The influence of low temperatures on the performance of a high-power single-frequency fiber laser amplifier is evaluated with a numerical simulation. Cooling the fiber can allow to take advantage of both higher damping of the acoustic waves in the silica glass, and higher laser efficiency. We first report on the measurement of the stimulated Brillouin scattering (SBS) threshold in a silica fiber as a function of the temperature from 300~K down to 77~K. We then present the measurements of small-signal absorption and gain spectra of an erbium doped alumino-phosphosilicate fiber, at room temperat…
Time-resolved femtosecond stimulated Raman spectroscopy (FSRS) is a powerful tool for investigating ultrafast structural and vibrational dynamics in light absorbing systems. However, the technique generally requires exposing a sample to high laser pulse fluences and long acquisition times to achieve adequate signal-to-noise ratios. Here, we describe a timeresolved FSRS instrument built around a Yb ultrafast amplifier operating at 200 kHz, and address some of the unique challenges that arise at high repetition-rates. The setup includes detection with a 9 kHz CMOS camera and an improved dual-cho…
Backward stimulated Raman scattering in gases provides a promising route to compression and amplification of a Stokes seed-pulse by counter-propagating against a pump-pulse, as has been already demonstrated in various platforms, mainly in free-space. However, the dynamics governing this process when seeded by noise has not yet been investigated in a fully controllable collinear environment. Here we report the first unambiguous observation of efficient noise-seeded backward stimulated Raman scattering in a hydrogen-filled hollow-core photonic crystal fiber. At high gas pressures, when the backw…
Erbium doped integrated waveguide amplifier and laser prevail in power consumption, footprint, stability and scalability over the counterparts in bulk materials, underpinning the lightwave communication and large-scale sensing. Subject to the highly confined mode and moderate propagation loss, gain and power scaling in such integrated micro-to-nanoscale devices prove to be more challenging compared to their bulk counterparts. In this work, stimulated by the prevalent success of double-cladding optical fiber in high-gain/power operation, a Ta2O5 cladding is employed in the erbium doped lithium …
Optical non-reciprocity, which breaks the symmetry between forward and backward propagating optical waves, has become vital in photonic systems and enables many key devices, such as optical isolators, circulators and optical routers. Most conventional optical isolators involve magneto-optic materials, but devices based on optical nonlinearities, optomechanically induced transparency and stimulated Brillouin scattering (SBS) have also been demonstrated. So far, however, they have only been implemented for linearly or randomly polarized LP01-like fundamental modes. Here we report a light-driven …
Optical amplifiers in all ranges of the electromagnetic spectrum exhibit two essential characteristics: i) the input signal during the propagation in the medium is multiplied by the avalanche effect of the stimulated emission to produce exponential growth and ii) the amplification saturates at increasing input signal. We demonstrate that the strong-field theory in the frame of high harmonic generation fully supports the appearance of both the avalanche and saturation effects in the amplification of extreme ultraviolet attosecond pulse trains. We confirm that the amplification takes place only …
We present an entirely fiber based laser source for non-linear imaging with a novel approach for multi-color excitation. The high power output of an actively modulated and amplified picosecond fiber laser at 1064 nm is shifted to longer wavelengths by a combination of four-wave mixing and stimulated Raman scattering. By combining different fiber types and lengths, we control the non-linear wavelength conversion in the delivery fiber itself and can switch between 1064 nm, 1122 nm, and 1186 nm on-the-fly by tuning the pump power of the fiber amplifier and modulate the seed diodes. This is a prom…
Atoms can scatter light and they can also amplify it by stimulated emission. From this simple starting point, we examine the possibility of realizing a random laser in a cloud of laser-cooled atoms. The answer is not obvious as both processes (elastic scattering and stimulated emission) seem to exclude one another: pumping atoms to make them behave as amplifier reduces drastically their scattering cross-section. However, we show that even the simplest atom model allows the efficient combination of gain and scattering. Moreover, supplementary degrees of freedom that atoms offer allow the use of…
