Superconducting nanowire single-photon detectors are an ideal match for integrated quantum photonic circuits due to their high detection efficiency for telecom wavelength photons. Quantum optical technology also requires single-photon detection with low dark count rate and high timing accuracy. Here we present very low noise superconducting nanowire single-photon detectors based on NbTiN thin films patterned directly on top of Si3N4 waveguides. We systematically investigate a large variety of detector designs and characterize their detection noise performance. Milli-Hz dark count rates are demonstrated over the entire operating range of the nanowire detectors which also feature low timing jitter. The ultra-low dark count rate, in combination with the high detection efficiency inherent to our traveling wave detector geometry, gives rise to a measured noise equivalent power at the 10^(-20) W/Hz^(1/2) level.
We demonstrate niobium titanium nitride superconducting nanowires patterned on stoichiometric silicon nitride waveguides for detecting visible and infrared photons. The use of silicon nitride on insulator on silicon substrates allows us to simultaneously realize photonic circuits for visible and infrared light and integrate them with nanowire detectors directly on-chip. By implementing a traveling wave detector geometry in this material platform, we achieve efficient single photon detection for both wavelength regimes. Our detectors are an ideal match for integrated quantum optics as they prov…
We present the characterization of two-dimensionally arranged 64-pixel NbTiN superconducting nanowire single-photon detector array for spatially resolved photon detection. NbTiN films deposited on thermally oxidized Si substrates enabled the high-yield production of high-quality SSPD pixels, and all 64 SSPD pixels showed uniform superconducting characteristics. Furthermore, all of the pixels showed single-photon sensitivity, and 60 of the 64 pixels showed a pulse generation probability higher than 90% after photon absorption. As a result of light irradiation from the single-mode optical fiber …
We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. The best device showed a system detection efficiency (DE) of 74%, dark count rate of 100 c/s, and full width at half maximum timing jitter of 68 ps under a bias current of 18.0 uA with a practical Gifford-McMahon cryocooler system. We also introduced six detectors into the cryocooler and confirmed that the system DE of all detectors was higher than 67% at the dark count rate of 100 c/s.
We report on simulation results that shows optimum photon absorption by superconducting nanowires can happen at a fill-factor that is much less than 100%. We also present experimental results on high performance of our superconducting nanowire single photon detectors realized using NbTiN on oxidized silicon.
We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of 50ps and a dark count rate of 3 Hz with unshielded fibers, allowing for identification of defects along the fiber over a dynamic range of 37.4 dB. Photons scattered and reflected back from the fiber under test can be detected in free-running mode without showing dead zones or other impairments often encountered in semiconductor photon-counting optical time doma…
In this paper, the design of superconducting-nanowire single-photon detectors which are insensitive to the polarization of the incident light is investigated. By using high-refractive-index dielectrics, the index mismatch between the nanowire and the surrounding media is reduced. This enhances the absorption of light with electric field vector perpendicular to the nanowire segments, which is generally hindered in this kind of detectors. Building on this principle and focusing on NbTiN nanowire devices, we present several easy-to-realize cavity architectures which allow high absorption efficien…
Triangular cross-section SiC photonic devices have been studied as an efficient and scalable route for integration of color centers into quantum hardware. In this work, we explore efficient collection and detection of color center emission in a triangular cross-section SiC waveguide by introducing a photonic crystal mirror on its one side and a superconducting nanowire single photon detector (SNSPD) on the other. Our modeled triangular cross-section devices with a randomly positioned emitter have a maximum coupling efficiency of 89 % into the desired optical mode and a high coupling efficiency…
In this paper several designs to maximize the absorption efficiency of superconducting-nanowire single-photon detectors are investigated. Using a simple optical cavity consisting of a gold mirror and a SiO2 layer, the absorption efficiency can be boosted to over 97%: this result is confirmed experimentally by the realization of an NbTiN-based detector having an overall system detection efficiency of 85% at 1.31 micrometers. Calculations show that by sandwiching the nanowire between two dielectric Bragg reflectors, unity absorption (> 99.9%) could be reached at the peak wavelength for optimized…
We experimentally investigate the performance of NbTiN superconducting nanowire single photon detectors above the base temperature of a conventional Gifford-McMahon cryocooler (2.5 K). By tailoring design and thickness (8 - 13 nm) of the detectors, high performance, high operating temperature, single-photon detection from the visible to telecom wavelengths are demonstrated. At 4.3 K, a detection efficiency of 82 % at 785 nm wavelength and a timing jitter of 30 $\pm$ 0.3 ps are achieved. In addition, for 1550 nm and similar operating temperature we measured a detection efficiency as high as 64 …
Single-photon detection with high efficiency, high timing resolution, low dark counts and high photon detection-rates is crucial for a wide range of optical measurements. Although efficient detectors have been reported before, combining all performance parameters in a single device remains a challenge. Here, we show a broadband NbTiN superconducting nanowire detector with an efficiency exceeding 92%, over 150MHz photon detection-rate, a dark count-rate below 130Hz, operated in a Gifford-McMahon cryostat. Furthermore, with careful optimization of the detector design and readout electronics, we …
At the core of an ideal single photon detector is an active material that ideally absorbs and converts photons to discriminable electronic signals. A large active material volume favours high-efficiency absorption, but often at the expense of conversion efficiency, noise, speed and timing accuracy. The present work demonstrates how the concept of coherent perfect absorption can be used to relax this trade-off for a waveguide-integrated superconducting nanowire single photon detector. A very short (8.5$μ$m long) and narrow (8$\times$35nm$^2$) U-shaped NbTiN nanowire atop a silicon-on-insulator …
We demonstrate propagation of plasmons in single crystalline silver nanostructures fabricated using a combination of a bottom-up and a top-down approach. Silver nanoplates of thickness around 65 nm and a surface area of about 100 μm^2 are made using a wet chemical method. Silver nanotips and nanowires are then sculptured by focused ion beam milling. The plasmons are excited by using the fluorescence from the redeposited silver clusters during the milling process. Propagation of plasmons in the nanowires is observed in the visible spectral region. We also observe a cavity effect by measuring th…
A broad range of scientific and industrial disciplines require precise optical measurements at very low light levels. Single-photon detectors combining high efficiency and high time resolution are pivotal in such experiments. By using relatively thick films of NbTiN (8-11\,nm) and improving the pattern fidelity of the nano-structure of the superconducting nanowire single-photon detectors (SNSPD), we fabricated devices demonstrating superior performance over all previously reported detectors in the combination of efficiency and time resolution. Our findings prove that small variations in the na…
Interfacing single photons and electrons is a crucial ingredient for sharing quantum information between remote solid-state qubits. Semiconductor nanowires offer the unique possibility to combine optical quantum dots with avalanche photodiodes, thus enabling the conversion of an incoming single photon into a macroscopic current for efficient electrical detection. Currently, millions of excitation events are required to perform electrical read-out of an exciton qubit state. Here we demonstrate multiplication of carriers from only a single exciton generated in a quantum dot after tunneling into …
A design for an ultra-high Q photonic crystal nanocavity engineered to interact with nitrogen-vacancy (NV) centers located near the surface of a single crystal diamond sample is presented. The structure is based upon a nanowire photonic crystal geometry, and consists of a patterned high refractive index membrane, such as gallium phosphide (GaP), supported by a diamond substrate. The nanocavity supports a mode with quality factor Q > 1.5 million and mode volume V < 0.52 (λ/n_\text{GaP})^3, and promises to allow Purcell enhanced collection of spontaneous emission from an NV located more than 50 …
The ability to detect single photons has become increasingly essential due to the rise of photon-based quantum computing. In this theoretical work, we propose a system consisting of a quantum dot (QD) side-coupled to a superconducting nanowire. The coupling opens a gap in both the QD mode and the Majorana zero mode (MZM) at the nanowire edge, enabling photon absorption in the system. We show that the absorbed photoelectron decays via rapid (sub-nanosecond to nanosecond) nonradiative heat transfer to the nanowire phonon modes rather than by spontaneous emission. Furthermore, we calculate the te…
Scalable, high speed data transfer between cryogenic (0.1-4 K) and room temperature environments is instrumental in a broad range of fields including quantum computing, superconducting electronics, single photon imaging and space-based communications. A promising approach to overcome the limitations of conventional wire-based readout is the use of optical fiber communication. Optical fiber presents a 100-1,000x lower heat load than conventional electrical wiring, relaxing the requirements for thermal anchoring, and is also immune to electromagnetic interference, which allows routing of sensiti…
High quality metal thin films and nanostructures are critical building blocks for next generation nanotechnologies. They comprise low-loss circuit elements in nanodevices, provide new catalytic pathways for water splitting and $CO_2$ reduction technologies, and enable the confinement of spatially extended electromagnetic waves to be harnessed for application in information processing, energy harvesting, engineered metamaterials, and new technologies that will operate in the quantum plasmonics limit. However, the controlled fabrication of high-definition single-crystal subwavelength metal nanos…
