CERN-Frejus中微子超束四喇叭系统脉冲电源的研究
Study of the pulse power supply unit for the four-horn system of the CERN to Frejus neutrino super beam
摘要:
本文讨论了CERN-Fréjus中微子超束振荡实验中四喇叭系统的电源研究。正在研究电源,以满足超级束质子驱动器的物理潜力和兆瓦功率要求。产生了最大电流为350 kA、脉宽为100 μs、频率为50 Hz的半正弦电流波形,并分配给四个喇叭。为了提供聚焦产生中微子束的带电介子所需的电流,一组电容器以50 Hz的频率充电到+12 kV的参考电压,然后通过一个大开关通过一组带状线以相同的速率放电到每个喇叭。电流恢复阶段允许在放电阶段之后快速地反转电容器的负电压,以便回收大部分注入的能量,从而限制功率消耗。该系统的能量回收效率非常高,达到97%。出于可行性原因,采用了模块化架构,其中8个模块并联连接,以向四喇叭系统提供44 kA的峰值电流。
英文摘要:
The power supply studies for the four-horn system for the CERN to Fréjus neutrino Super Beam oscillation experiment are discussed here. The power supply is being studied to meet the physics potential and the mega-watt (MW) power requirements of the proton driver of the Super Beam. A one-half sinusoid current waveform with a 350 kA maximum current and pulse length of 100 μs at 50 Hz frequency is generated and distributed to four-horns. In order to provide the necessary current needed to focus the charged mesons producing the neutrino beam, a bench of capacitors is charged at 50 Hz frequency to a +12 kV reference voltage and then discharged through a large switch to each horn via a set of strip-lines at the same rate. A current recovery stage allows to invert rapidly the negative voltage of the capacitor after the discharging stage in order to recuperate large part of the injected energy and thus to limit the power consuption. The energy recovery efficiency of that system is very high at 97%. For feasibility reasons, a modular architecture has been adopted with 8 modules connected in parallel to deliver 44 kA peak currents into the four-horn system.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。