Recent research results have demonstrated the feasibility of full-duplex wireless communication for short-range links. Although the focus of the previous works has been active cancellation of the self-interference signal, a majority of the overall self-interference suppression is often due to passive suppression, i.e., isolation of the transmit and receive antennas. We present a measurement-based study of the capabilities and limitations of three key mechanisms for passive self-interference suppression: directional isolation, absorptive shielding, and cross-polarization. The study demonstrates that more than 70 dB of passive suppression can be achieved in certain environments, but also establishes two results on the limitations of passive suppression: (1) environmental reflections limit the amount of passive suppression that can be achieved, and (2) passive suppression, in general, increases the frequency selectivity of the residual self-interference signal. These results suggest two design implications: (1) deployments of full-duplex infrastructure nodes should minimize near-antenna reflectors, and (2) active cancellation in concatenation with passive suppression should employ higher-order filters or per-subcarrier cancellation.
Loop interference (LI) in wireless communications, is a notion resulting from the full-duplex (FD) operation. In a large-scale network, FD also increases the multiuser interference due to the large number of active wireless links that exist. Hence, in order to realize the FD potentials, this interference needs to be restricted. This paper presents a stochastic geometry model of FD cellular networks where the users and base stations employ directional antennas. Based on previous experimental results, we model the passive suppression of the LI at each FD terminal as a function of the angle betwe…
This paper investigates the passive beamforming and deployment design for an intelligent reflecting surface (IRS) aided full-duplex (FD) wireless system, where an FD access point (AP) communicates with an uplink (UL) user and a downlink (DL) user simultaneously over the same time-frequency dimension with the help of IRS. Under this setup, we consider three deployment cases: 1) two distributed IRSs placed near the UL user and DL user, respectively; 2) one centralized IRS placed near the DL user; 3) one centralized IRS placed near the UL user. In each case, we aim to minimize the weighted sum tr…
Millimeter wave (mmWave) full-duplex (FD) is a promising technique for improving capacity by maximizing the utilization of both time and the rich mmWave frequency resources. Still, it has restrictions due to FD self-interference (SI) and mmWave's limited coverage. Therefore, this study dives into FD mmWave MIMO with the assistance of reconfigurable intelligent surfaces (RIS) for capacity improvement. First, we demonstrate the angular-domain reciprocity of FD antenna arrays under the far-field planar wavefront assumption. Accordingly, a strategy for joint downlink-uplink (DL-UL) channel estimat…
We present an experiment-based characterization of passive suppression and active self-interference cancellation mechanisms in full-duplex wireless communication systems. In particular, we consider passive suppression due to antenna separation at the same node, and active cancellation in analog and/or digital domain. First, we show that the average amount of cancellation increases for active cancellation techniques as the received self-interference power increases. Our characterization of the average cancellation as a function of the self-interference power allows us to show that for a constan…
This paper studies intelligent reflecting surface (IRS)-aided full-duplex (FD) wireless-powered communication network (WPCN), where a hybrid access point (HAP) broadcasts energy signals to multiple devices for their energy harvesting in the downlink (DL) and meanwhile receives information signals in the uplink (UL) with the help of IRS. Particularly, we propose three types of IRS beamforming configurations to strike a balance between the system performance and signaling overhead as well as implementation complexity. We first propose the fully dynamic IRS beamforming, where the IRS phase-shift …
In this paper, we investigate the secrecy capacity of a point-to-point, full-duplex (FD) wirelesly powered communication system in the presence of a passive eavesdropper (EVE). The considered system is comprised of an energy transmitter (ET), an energy harvesting user (EHU), and a passive EVE. The ET transmits radio-frequency energy, which is used for powering the EHU as well as for generating interference at the EVE. The EHU uses the energy harvested from the ET to transmit confidential messages back to the ET. As a consequence of the FD mode of operation, both the EHU and the ET are subjecte…
Recent experimental results have shown that full-duplex communication is possible for short-range communications. However, extending full-duplex to long-range communication remains a challenge, primarily due to residual self-interference even with a combination of passive suppression and active cancellation methods. In this paper, we investigate the root cause of performance bottlenecks in current full-duplex systems. We first classify all known full-duplex architectures based on how they compute their cancelling signal and where the cancelling signal is injected to cancel self-interference. B…
Full-duplex systems are expected to achieve 100% rate improvement over half-duplex systems if the self-interference signal can be significantly mitigated. In this paper, we propose the first full-duplex system utilizing Multi-Reconfigurable Antenna (MRA) with ?90% rate improvement compared to half-duplex systems. MRA is a dynamically reconfigurable antenna structure, that is capable of changing its properties according to certain input configurations. A comprehensive experimental analysis is conducted to characterize the system performance in typical indoor environments. The experiments are pe…
In this paper, we consider the achievable sum secrecy rate in MISO (multiple-input-single-output) {\em full-duplex} wiretap channel in the presence of a passive eavesdropper and imperfect channel state information (CSI). We assume that the users participating in full-duplex communication have multiple transmit antennas, and that the users and the eavesdropper have single receive antenna each. The users have individual transmit power constraints. They also transmit jamming signals to improve the secrecy rates. We obtain the achievable perfect secrecy rate region by maximizing the worst case sum…
We consider linear precoder design for a multiple-input multiple-output (MIMO) Gaussian wiretap channel, which comprises two legitimate nodes, i.e., Alice and Bob, operating in Full-Duplex (FD) mode and exchanging confidential messages in the presence of a passive eavesdropper. Using the sum secrecy degrees of freedoms (sum S.D.o.F.) as reliability measure, we formulate an optimization problem with respect to the precoding matrices. In order to solve this problem, we first propose a cooperative secrecy transmission scheme, and prove that its feasible set is sufficient to achieve the maximum su…
In this paper, we consider two fundamental full-duplex (FD) architectures, two-node and three-node, in the context of cellular networks where the terminals employ directional antennas. The simultaneous transmission and reception of data in non-orthogonal channels makes FD radio a potential solution for the currently limited spectrum. However, its implementation generates high levels of interference either in the form of loopback interference (LI) from the output to the input antenna of a transceiver or in the form of co-channel interference in large-scale multicell networks due to the large nu…
This letter considers the secure communication in a reconfigurable intelligent surface (RIS) aided full duplex (FD) system. An FD base station (BS) serves an uplink (UL) user and a downlink (DL) user simultaneously over the same time-frequency dimension assisted by a RIS in the presence of an eavesdropper. In addition, the artificial noise (AN) is also applied to interfere the eavesdropper's channel. We aim to maximize the sum secrecy rate of UL and DL users by jointly optimizing the transmit beamforming, receive beamforming and AN covariance matrix at the BS, and passive beamforming at the RI…
Future Internet-of-Things (IoT) is expected to wirelessly connect billions of low-complexity devices. For wireless information transfer (WIT) in IoT, high density of IoT devices and their ad hoc communication result in strong interference which acts as a bottleneck on WIT. Furthermore, battery replacement for the massive number of IoT devices is difficult if not infeasible, making wireless energy transfer (WET) desirable. This motivates: (i) the design of full-duplex WIT to reduce latency and enable efficient spectrum utilization, and (ii) the implementation of passive IoT devices using backsc…
Millimeter wave (mmWave) vehicular channels are highly dynamic, and the communication link needs to be reconfigured frequently. In this work, we propose to use a passive radar receiver at the roadside unit to reduce the training overhead of establishing an mmWave communication link. Specifically, the passive radar will tap the transmissions from the automotive radars of the vehicles on the road. The spatial covariance of the received radar signals will be estimated and used to establish the communication link. We propose a simplified radar receiver that does not require the transmitted wavefor…
The fundamental problem in the design of a full-duplex radio is the cancellation of the self-interference (SI) signal generated by the transmitter.Current techniques for suppressing SI rely on generating a copy of the SI signal and subtracting it partly in the RF (radio frequency) and digital domains. A critical step in replicating the self-interference is the estimation of the multi-path channel through which the transmitted signal propagates to the antenna. Since there is no prior model on the number of multipath reflections, current techniques assume a tap delay line filter (in the RF and d…
This paper develops a new cooperative jamming protocol, termed accumulate-and-jam (AnJ), to improve physical layer security in wireless communications. Specifically, a full-duplex (FD) friendly jammer is deployed to secure the direct communication between source and destination in the presence of a passive eavesdropper. We consider the friendly jammer as an energy-constrained node without embedded power supply but with an energy harvesting unit and rechargeable energy storage; it can thus harvest energy from the radio frequency (RF) signals transmitted by the source, accumulate the energy in i…
This chapter focuses on the performance enhancement brought by the addition of caching capabilities to full-duplex (FD) radios in the context of ultra-dense networks (UDNs). More specifically, we aim at showing that the interference footprint of such networks, i.e., the major bottleneck to overcome to observe the theoretical FD throughput doubling at the network level, can be significantly reduced thanks to edge caching. Fundamental results show that most of the gain, as compared to their half-duplex (HD) counterparts, can be achieved by such networks only if costly modifications to their infr…
Internet of Things (IoT) networks for smart sensor nodes in the next generation of smart wireless sensing systems require a distributed security scheme to prevent the passive (eavesdropping) or active (jamming and interference) attacks from untrusted sensor nodes. This paper concerns advancing the security of the IoT system to address their vulnerability to being attacked or compromised by the advancement of future supercomputers. In this work, a novel embedded architecture has been designed and implemented for a distributed IoT network that utilizes a master-slave full-duplex communication to…
Reconfigurable intelligent surface (RIS) is an emerging technique employing metasurface to reflect the signal from the source node to the destination node without consuming any energy. Not only the spectral efficiency but also the energy efficiency can be improved through RIS. Essentially, RIS can be considered as a passive relay between the source and destination node. On the other hand, a relay node in a traditional relay network has to be active, which indicates that it will consume energy when it is relaying the signal or information between the source and destination nodes. In this paper,…
