arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1301.0382cond-mat.softq-bio.BM
收藏

使用polymer刷解离的光-机械能转换

Photo-mechanical energy conversion using polymer brush dissociation

J. M. Deutsch

摘要:

研究了一种利用聚合物和光解离将光连续地直接转化为机械能的装置。将拴在表面上的聚合物刷与其上方一小段距离处的平行板接触,该平行板包含结合聚合物和光可以发生光解离的反应位点。在适当的条件下,这些聚合物的集体效应是施加平行于板的力,将入射光转化为机械功。进行了数值计算,以了解这种效果,三维朗之万模拟,福克普朗克方程的解决方案,和一维蒙特卡罗模拟。Fokker Planck方程的理论分析被用来研究一个模型,在该模型中,未结合态发生平衡,并且在结合态中达到亚稳态平衡。它表明,每个周期的工作可以做得比热能大得多,但在需要一个大大降低的光解速率为代价。讨论了优化机械能转换的参数。

英文摘要:

A device is investigated that continuously and directly converts light into mechanical energy, using polymers and photodissociation. A polymer brush tethered to a surface, is brought into contact with a parallel plate a small distance above it that contains reaction sites where photodissociation of bound polymer and light can occur. Under the appropriate conditions, the collective effect of these polymers is to apply a force parallel to the plates, converting incoming light into mechanical work. Numerical work is carried out to understand this effect, a three dimensional Langevin simulation, solution to the Fokker Planck equation, and a one dimensional Monte Carlo simulation. Theoretical analysis of the Fokker Planck equation is used to study a model where equilibration of the unbound state occurs and equilibration to a metastable equilibrium is achieved in the bound state. It is shown that the work per cycle can be made much larger than the thermal energy but at the expense of requiring a greatly diminished photodissociation rate. Parameters are discussed in order optimize mechanical energy conversion.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑