电容式和频率式加速度计在微纳机电系统中的应用比较
Comparison of capacitive and frequential readout when scaling accelerometers down from Micro- to Nano- Electro Mechanical Systems
摘要:
本文展示了将硅加速度计从MEMS缩小到NEMS的效果。它为电容和谐振设备的电子和布朗噪声源建模,并计算可达到的最小可检测信号。计算结果与已发表的实验结果非常接近。它显示了谐振情况下的品质因数和梁宽度的相对较低的影响。不同的缩放规则进行了研究,它似乎谐振感测可以满足一些新的应用要求,特别是对于低于几百纳米的关键尺寸,当它比电容感测更好地解决。
英文摘要:
This paper shows the effect of scaling silicon accelerometers down from MEMS to NEMS. It models both electronics and Brownian noise sources for both capacitive and resonant devices, and computes the minimum detectable signal attainable. Computed results are remarkably close to published experimental results. It shows the relatively low influence of the quality factor and of the beam width in the resonant case. Different scaling rules are investigated, and it appears that resonant sensing may satisfy some new application requirements, in particular for critical dimensions below a few hundreds of nm, when it is better resolved than capacitive sensing.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。