用于非线性光学应用的GaN/AlGaN一维光子晶体的制备
Fabrication of GaN/AlGaN 1D photonic crystals designed for nonlinear optical applications
摘要:
本文提出了一种制备GAN/AlGaN一维光子晶体(1D-PhC)微腔的可靠工艺。我们使用了异质结构,其中GAN层嵌入在蓝宝石衬底上的由AlGaN/GAN多层膜组成的两个分布式布拉格反射器之间,被设计为从λ= 400 nm的入射泵浦信号产生λ= 800 nm的频率下转换信号(χ^(2)效应)。该异质结构通过金属有机化学气相沉积(MOCVD)外延生长,并集成了适当设计的1D-PhC光栅,该光栅通过利用腔共振和非线性GAN增强的双重效应来放大信号。采用高分辨率电子束写入和深腐蚀相结合的方法制备了集成一维光子晶体微腔。对于图案转移,我们使用通过基于使用双层抗蚀剂(PMMA/MMA)的高质量剥离技术获得的~ 170 nm层Cr金属蚀刻掩模。同时,等离子体条件已经被优化,以实现具有良好的侧壁垂直度(非常接近90°)的深度蚀刻结构(深度超过1微米)。在将图案转移到GAN/AlGaN异质结构之后,实现了具有良好控制的尺寸(周期分别为150 nm、230 nm和400 nm)的光栅。
英文摘要:
In this paper we present a reliable process to fabricate GaN/AlGaN one dimensional photonic crystal (1D-PhC) microcavities with nonlinear optical properties. We used a heterostructure with a GaN layer embedded between two Distributed Bragg Reflectors consisting of AlGaN/GaN multilayers, on sapphire substrate, designed to generate a λ= 800 nm frequency down-converted signal (χ^(2) effect) from an incident pump signal at λ= 400 nm. The heterostructure was epitaxially grown by metal organic chemical vapour deposition (MOCVD) and integrates a properly designed 1D-PhC grating, which amplifies the signal by exploiting the double effect of cavity resonance and non linear GaN enhancement. The integrated 1D-PhC microcavity was fabricate combing a high resolution e-beam writing with a deep etching technique. For the pattern transfer we used ~ 170 nm layer Cr metal etch mask obtained by means of high quality lift-off technique based on the use of bi-layer resist (PMMA/MMA). At the same time, plasma conditions have been optimized in order to achieve deeply etched structures (depth over 1 micron) with a good verticality of the sidewalls (very close to 90°). Gratings with well controlled sizes (periods of 150 nm, 230 nm and 400 nm respectively) were achieved after the pattern is transferred to the GaN/AlGaN heterostructure.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。