arXivDaily arXiv每日学术速递 周一至周五更新
arXiv周末暂无论文更新,休息一下吧,周末愉快~~
arXiv 1011.4982cond-mat.supr-con
收藏

超导量子比特大芯片安装中的线键串扰和腔模

Wirebond crosstalk and cavity modes in large chip mounts for superconducting qubits

J. Wenner, M. Neeley, Radoslaw C. Bialczak, M. Lenander, Erik Lucero, A. D. O'Connell, D. Sank, H. Wang, M. Weides, A. N. Cleland, John M. Martinis

摘要:

我们分析的微波芯片安装,使用引线键合连接芯片和安装地面的性能。一个简单的阻抗阶梯模型预测,两个馈线之间的传输串扰下降指数的距离在低频率,但上升到接近统一以上的芯片对地电容设置的谐振频率。利用SPICE模拟和缩尺模型的实验测量,验证了阶梯模型的基本预测。特别地,通过减小芯片和盒接地之间的电容,谐振频率增加并且传输降低。该模型随后影响了新安装的设计,该安装在6 GHz时将隔离度提高到-65 dB,尽管芯片尺寸增加到1 cm × 1 cm,是我们以前器件的3倍。我们在这个底座上测量了一个共面谐振器,为更大的量子位芯片做准备,并且能够识别腔,槽线和谐振器模式。

英文摘要:

We analyze the performance of a microwave chip mount that uses wirebonds to connect the chip and mount grounds. A simple impedance ladder model predicts that transmission crosstalk between two feedlines falls off exponentially with distance at low frequencies, but rises to near unity above a resonance frequency set by the chip to ground capacitance. Using SPICE simulations and experimental measurements of a scale model, the basic predictions of the ladder model were verified. In particular, by decreasing the capacitance between the chip and box grounds, the resonance frequency increased and transmission decreased. This model then influenced the design of a new mount that improved the isolation to -65 dB at 6 GHz, even though the chip dimensions were increased to 1 cm by 1 cm, 3 times as large as our previous devices. We measured a coplanar resonator in this mount as preparation for larger qubit chips, and were able to identify cavity, slotline, and resonator modes.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑