arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 1009.4556cs.RO
收藏

机器人动力学参数辨识的闭环输出误差新方法

A new closed-loop output error method for parameter identification of robot dynamics

Université de Nantes(南特大学);HAPTION S.A(哈普申公司);Laboratoire Central des Ponts et Chaussées(法国路桥中央实验室)

Maxime Gautier, Alexandre Janot, Pierre-Olivier Vandanjon

摘要:

离线机器人动力学辨识方法大多基于逆动力学模型的使用,逆动力学模型相对于动力学参数是线性的。当机器人跟踪激励系统动力学的参考轨迹时,对该模型进行采样。这允许使用线性最小二乘技术来估计参数。通过对多台样机和工业机器人的实验识别,证明了该方法的有效性。然而,该方法需要通过以高采样率对关节位置进行带通滤波来进行关节力/扭矩和位置测量以及关节速度和加速度的估计。所提出的新方法只需要关节力/扭矩测量。这是一种闭环输出误差方法,其中通常的关节位置输出被关节力/扭矩代替。它是基于一个闭环仿真的机器人使用的直接动力学模型,相同的结构的控制律,和相同的参考轨迹的实际和模拟的机器人。最佳参数最小化实际力/扭矩和模拟力/扭矩之间的误差的2-范数。这是一个非线性最小二乘问题,使用逆动力学模型可以大大简化该问题,以获得模拟力/扭矩的解析表达式,参数为线性。通过对一个2自由度直接驱动机器人的实验验证了该方法的有效性。

英文摘要:

Off-line robot dynamic identification methods are mostly based on the use of the inverse dynamic model, which is linear with respect to the dynamic parameters. This model is sampled while the robot is tracking reference trajectories that excite the system dynamics. This allows using linear least-squares techniques to estimate the parameters. The efficiency of this method has been proved through the experimental identification of many prototypes and industrial robots. However, this method requires the joint force/torque and position measurements and the estimate of the joint velocity and acceleration, through the bandpass filtering of the joint position at high sampling rates. The proposed new method requires only the joint force/torque measurement. It is a closed-loop output error method where the usual joint position output is replaced by the joint force/torque. It is based on a closed-loop simulation of the robot using the direct dynamic model, the same structure of the control law, and the same reference trajectory for both the actual and the simulated robot. The optimal parameters minimize the 2-norm of the error between the actual force/torque and the simulated force/torque. This is a non-linear least-squares problem which is dramatically simplified using the inverse dynamic model to obtain an analytical expression of the simulated force/torque, linear in the parameters. A validation experiment on a 2 degree-of-freedom direct drive robot shows that the new method is efficient.

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑