多层膜中纳米管的力学性能
Mechanical properties of nanotubes of polyelectrolyte multilayers
摘要:
通过共振接触原子力显微镜(AFM)研究了聚电解质在聚碳酸酯径迹蚀刻膜的纳米孔中的逐层(LBL)组装制备的纳米管的弹性性质,纳米管直径在100至200 nm的范围内。的纳米管的弹性模量计算从自由悬挂的LbL纳米管上的悬臂梁的共振频率。在空气中发现这些纳米结构的杨氏模量的平均值为115MPa,远低于干燥平坦多层膜所报道的值,但在水溶胀平坦多层膜所报道的值的范围内。这些低的值是最有可能的是由于LbL纳米管的离子交联的程度较低,并因此在空气中的水含量较高,从nanobolized纳米多层膜的生长的特殊模式。
英文摘要:
The elastic properties of nanotubes fabricated by layer-by-layer (LbL) assembly of polyelectrolytes in the nanopores of polycarbonate track-etched membranes have been investigated by resonant contact Atomic Force Microscopy (AFM), for nanotube diameters in the range of 100 to 200 nm. The elastic modulus of the nanotubes was computed from the resonance frequencies of a cantilever resting on freely suspended LbL nanotubes. An average value of 115MPa was found in air for Young's modulus of these nanostructures, well below the values reported for dry, flat multilayers, but in the range of values reported for water-swollen flat multilayers. These low values are most probably due to the lower degree of ionic cross-linking of LbL nanotubes and their consequently higher water content in air, resulting from the peculiar mode of growth of nanoconfined polyelectrolyte multilayers.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。