高迁移率栅控InSb/InAlSb量子阱异质结构的高场磁输运
High field magneto-transport in high mobility gated InSb/InAlSb quantum well heterostructures
摘要:
我们提出了一系列30 nm宽的InSb/InAlSb量子阱的高场磁输运数据。研究的样品的低温载流子迁移率范围为18.4至39.5 m2 V-1 s-1,载流子密度在1.5x1015和3.28x1015 m-2之间。报道室温迁移率超过6 m2 V-1 s-1。结果表明,朗道能级展宽随载流子密度的增加而减小,尽管存在较大的g因子,但在具有非零节点振幅的样品中,仍观察到朗道能级展宽的磁电阻拍频模式。拍频是由于Rashba分裂现象和Rashba耦合参数提取的自旋布居的差异范围内的样品和栅极偏置。通过对磁导的模拟研究了朗道能级展宽和自旋相关散射率对Shubnikov-de Haas振荡拍频观测的影响。具有非零拍节点振幅的数据伴随着傅里叶变换中的非对称峰,这通过在模拟中引入自旋相关的加宽而成功地再现。据发现,低能量(多数)自旋向上的状态遭受更多的散射比高能量(少数)自旋向下的状态,并在大多数(低密度)样品中的拍频图案的情况下,可以归因于相同的效果时,水平加宽的幅度是大的。
英文摘要:
We present high field magneto-transport data from a range of 30nm wide InSb/InAlSb quantum wells. The low temperature carrier mobility of the samples studied ranged from 18.4 to 39.5 m2V-1s-1 with carrier densities between 1.5x1015 and 3.28x1015 m-2. Room temperature mobilities are reported in excess of 6 m2V-1s-1. It is found that the Landau level broadening decreases with carrier density and beating patterns are observed in the magnetoresistance with non-zero node amplitudes in samples with the narrowest broadening despite the presence of a large g-factor. The beating is attributed to Rashba splitting phenomenon and Rashba coupling parameters are extracted from the difference in spin populations for a range of samples and gate biases. The influence of Landau level broadening and spin-dependent scattering rates on the observation of beating in the Shubnikov-de Haas oscillations is investigated by simulations of the magnetoconductance. Data with non-zero beat node amplitudes are accompanied by asymmetric peaks in the Fourier transform, which are successfully reproduced by introducing a spin-dependent broadening in the simulations. It is found that the low-energy (majority) spin up state suffers more scattering than the high-energy (minority) spin down state and that the absence of beating patterns in the majority of (lower density) samples can be attributed to the same effect when the magnitude of the level broadening is large.
机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。