Effects of axial torsion on sp carbon atomic nanowires
Luca Ravagnan, Nicola Manini, Eugenio Cinquanta, Giovanni Onida, Davide Sangalli, Carlo Motta, Michele Devetta, Andrea Bordoni, Paolo Piseri, Paolo Milani
Ab-initio calculations within Density Functional Theory combined with experimental Raman spectra on cluster-beam deposited pure carbon films provide a consistent picture of sp-carbon chains stabilized by sp^3 or sp^2 terminations, the latter being sensitive to torsional strain. This unexplored effect promises many exciting applications since it allows one to modify the conductive states near the Fermi level and to switch on and off the on-chain pi-electron magnetism.
We calculate the thermoelectric figure of merit, zT=S^2GT/(κ_l+κ_e), for p-type Si nanowires with axial Ge heterostructures using a combination of first-principles density-functional theory, interatomic potentials, and Landauer-Buttiker transport theory. We consider nanowires with up to 8400 atoms and twelve Ge axial heterostructures along their length. We find that introducing heterostructures always reduces S^2G, and that our calculated increases in zT are predominantly driven by associated decreases in κ_l. Of the systems considered, <111> nanowires with a regular distribution of Ge heteros…
The addition of boron to GaAs nanowires grown by self-catalyzed molecular beam epitaxy was found to have a strong effect on the nanowire morphology, with axial growth greatly reduced as the nominal boron concentration was increased. Transmission electron microscopy measurements show that the Ga catalyst droplet was unintentionally consumed during growth. Concurrent radial growth, a rough surface morphology and tapering of nanowires grown under boron flux suggest that this droplet consumption is due to reduced Ga adatom diffusion on the nanowire sidewalls in the presence of boron. Modelling of …
We report on the growth of axial InAs-on-GaAs nanowire heterostructures on silicon by molecular beam epitaxy using 20 nm diameter Au catalysts. First, the growth parameters of the GaAs nanowire segment were optimized to achieve a pure wurtzite crystal structure. Then, we developed a two-step growth procedure to enhance the yield of vertical InAs-on-GaAs nanowires. We achieved 90% of straight InAs-on-GaAs nanowires by further optimizing the growth parameters. We investigated the composition change at the interface by energy dispersive X-ray spectroscopy and the nanowire crystal structure by tra…
The article presents a mapping of the residual strain along the axis of InAs/InSb heterostructured nanowires. Using confocal Raman measurements, we observe a gradual shift in the TO phonon mode along the axis of these nanowires. We attribute the observed TO phonon shift to a residual strain arising from the InAs/InSb lattice mismatch. We find that the strain is maximum at the interface and then monotonically relaxes towards the tip of the nanowires. We also analyze the crystal structure of the InSb segment through selected area electron diffraction measurements and electron diffraction tomogra…
We study the three-dimensional deformation field induced by an axial (In,Ga)N segment in a GaN nanowire. Using the finite element method within the framework of linear elasticity theory, we study the dependence of the strain field on the ratio of segment length and nanowire radius. Contrary to intuition, the out-of-plane-component of the elastic strain tensor is found to assume large negative values for a length-to-radius ratio close to one. We show that this unexpected effect is a direct consequence of the deformation of the nanowire at the free sidewalls and the associated large shear strain…
Bi-containing III-V semiconductors constitute an exciting class of metastable compounds with wide-ranging potential optoelectronic and electronic applications. However, the growth of III-V-Bi alloys requires group-III-rich growth conditions, which pose severe challenges for planar growth. In this work, we exploit the naturally-Ga-rich environment present inside the metallic droplet of a self-catalyzed GaAs nanowire to synthesize metastable GaAs/GaAs$_{1-\text{x}}$Bi$_{\text{x}}$ axial nanowire heterostructures with high Bi contents. The axial GaAs$_{1-\text{x}}$Bi$_{\text{x}}$ segments are rea…
Controlling the strain level in nanowire heterostructures is critical for obtaining coherent interfaces of high crystalline quality and for the setting of functional properties such as photon emission, carrier mobility or piezoelectricity. In a nanowire axial heterostructure featuring a sharp interface, strain is set by the materials lattice mismatch and the nanowire radius. Here, we show that introducing a graded interface in nanowire heterostructures offers an additional parameter to control strain. For a given interface length and lattice mismatch, we first derive theoretically the maximum …
(In,Ga)N insertions embedded in self-assembled GaN nanowires are of current interest for applications in solid state light emitters. Such structures exhibit a notoriously broad emission band. We use cathodoluminescence spectral imaging in a scanning electron microscope and micro-photoluminescence spectroscopy on single nanowires to learn more about the mechanisms underlying this emission. We observe a shift of the emission energy along the stack of six insertions within single nanowires that may be explained by compositional pulling. Our results also corroborate reports that the localization o…
Diffusion-enhanced and desorption-limited growth regimes of Ga-assisted GaAs nanowires were identified. In the latter regime, the number of vertical NWs with a narrow length distribution was increased by raising the growth temperature. The maximum axial growth rate; which can be quantified by the supplied rate of As atoms, is achieved when a dynamical equilibrium state is maintained in Ga droplets i.e. the number of impinging As atoms on the droplet surface is equivalent to that of direct deposited Ga atoms combining with the diffusing ones. The contribution of Ga diffusion to the wire growth …
Hybrid silicon nanowires with an integrated light-emitting segment can significantly advance nanoelectronics and nanophotonics. They would combine transport and optical characteristics in a nanoscale device, which can operate in the fundamental single-electron and single-photon regime. III-V materials, such as direct bandgap gallium-arsenide, are excellent candidates for such optical segments. However, interfacing them with silicon during crystal growth is a major challenge, because of the lattice mismatch, different expansion coefficients and the formation of anti-phase boundaries. Here, we d…
Monolithic axial InGaAs quantum dot emitters in GaAs-based nanowires via Sb-mediated facet engineering
Walter Schottky Institute, TUM School of Natural Sciences, Technical University of Munich（慕尼黑工业大学沃尔特·施科特基研究所自然科学学院）；Institute for Physics and Astronomy, Technical University Berlin（柏林工业大学物理与天文学研究所）；Department of Chemistry, Ludwig-Maximilians-University of Munich（慕尼黑大学化学系）；Walter Schottky Institute, TUM School of Computation, Information and Technology, Technical University of Munich（慕尼黑工业大学沃尔特·施科特基研究所计算、信息与技术学院）；Department of Physics, University of California, Berkeley（加州大学伯克利分校物理系）
Nanowire devices have long been proposed as an efficient alternative to their planar counterparts for different optoelectronic applications. Unfortunately, challenges related to the growth and characterization of doping and p-n junction formation in nanowire devices (along axial or radial axis) have significantly impeded their development. The problems are further amplified if a p-n junction has to be implemented radially. Therefore, even though radial junction devices are expected to be on par with their axial junction counterparts, there are minimal reports on high-performance radial junctio…
In this paper it is demonstrated that only by accounting for the combined effects of anisotropy and tension-compression asymmetry both at single crystal and polycrystal levels, it is possible to explain and accurately predict the peculiarities of the room-temperature torsional response of a strongly textured AZ31 Mg material. This is shown by using two modeling frameworks, namely: the viscoplastic self-consistent (VPSC) polycrystal model that accounts for tension-compression asymmetry of the mechanical response of a polycrystalline aggregate due to the occurrence of twinning at single crystal …
We have investigated in-situ Si doping of InAs nanowires grown by molecular beam epitaxy from gold seeds. The effectiveness of n-type doping is confirmed by electrical measurements showing an increase of the electron density with the Si flux. We also observe an increase of the electron density along the nanowires from the tip to the base, attributed to the dopant incorporation on the nanowire facets whereas no detectable incorporation occurs through the seed. Furthermore the Si incorporation strongly influences the lateral growth of the nanowires without giving rise to significant tapering, re…
We have investigated the vibrational density of states (VDOS) of a thin Cu nanowire with $<100>$ axial orientation and considered the effect of axial strain. The VDOS are calculated using a real space Green's function approach with the force constant matrices extracted from interaction potential based on the embedded atom method. Results for the vibrational density of states of a strain-free nanowire show quite distinctive characteristics compared to that of a bulk atom, the most striking feature of which is the existence of high frequency modes above the top of the bulk spectrum. We further p…
We utilize classical molecular dynamics to study surface effects on the piezoelectric properties of ZnO nanowires as calculated under uniaxial loading. An important point to our work is that we have utilized two types of surface treatments, those of charge compensation and surface passivation, to eliminate the polarization divergence that otherwise occurs due to the polar (0001) surfaces of ZnO. In doing so, we find that if appropriate surface treatments are utilized, the elastic modulus and the piezoelectric properties for ZnO nanowires having a variety of axial and surface orientations are a…
Straight, axial InAs nanowire with multiple segments of GaInAs were grown. High resolution X-ray energy-dispersive spectroscopy (EDS) mapping reveal the distribution of group III atoms at the axial interfaces and at the sidewalls. Significant Ga enrichment, accompanied by a structural change is observed at the GaInAs/InAs interfaces and a higher Ga concentration for the early grown GaInAs segments. The elemental map and EDS line profile infer Ga enrichment at the facet junctions between the sidewalls. The relative chemical potentials of ternary alloys and the thermodynamic driving force for li…
Study on mechanical properties of one-dimensional layered titanate nanomaterials is crucial since they demonstrate important applications in various fields. Here, we conducted ex situ and in situ atomic-scale investigation on bending properties of a kind of ceramic layered titanate (Na2Ti2O4(OH)2) nanowires in a transmission electron microscopy. The nanowires showed flexibility along <100> direction and could obtain a maximum bending strain of nearly 37%. By analysing the defect behaviours, the unique bending properties of this ceramic material was found to correlate with a novel arrangement o…
It is found that all the zigzag chains except the nonmagnetic (NM) Ni and antiferromagnetic (AF) Fe chains which form a twisted two-legger ladder, look like a corner-sharing triangle ribbon, and have a lower total energy than the corresponding linear chains. All the 3d transition metals in both linear and zigzag structures have a stable or metastable ferromagnetic (FM) state. The electronic spin-polarization at the Fermi level in the FM Sc, V, Mn, Fe, Co and Ni linear chains is close to 90% or above. In the zigzag structure, the AF state is more stable than the FM state only in the Cr chain. I…
Recent molecular dynamic simulations have found chiral single wall carbon nanotubes (SWNTs) twist during stretching, which is similar to the motion of a screw. Obviously this phenomenon, as a type of curvature-chirality effect, can not be explained by usual isotropic elastic theory of SWNT. More interestingly, with larger axial strains (before buckling), the axial strain induced torsion (a-SIT) shows asymmetric behaviors for axial tensile and compressing strains, which suggests anharmonic elasticity of SWNTs plays an important role in real a-SIT responses. In order to study the a-SIT of chiral…
We observe a systematic red shift of the band-edge of passivated GaAs/Al0.35Ga0.65As core-shell nanowires with increasing shell thickness up to 100 nm. The shift is detected both in emission and absorption experiments, reaching values up to 14 meV for the thickest shell nanowires. Part of this red shift is accounted for by the small tensile strain imposed to the GaAs core by the AlGaAs shell, in line with theoretical calculations. An additional contribution to this red shift arises from axial piezoelectric fields which develop inside the nanowire core due to Al fluctuations in the shell.
Using an approximate time-dependent density functional theory method, we calculate the absorption and luminescence spectra for hydrogen passivated silicon nanoscale structures with large aspect ratio. The effect of electron confinement in axial and radial directions is systematically investigated. Excited state relaxation leads to significant Stokes shifts for short nanorods with lengths less than 2 nm, but has little effect on the luminescence intensity. The formation of self-trapped excitons is likewise observed for short nanostructures only; longer wires exhibit fully delocalized excitons w…
We investigate theoretically the effects of elastic and plastic deformations on heterogeneous nucleation and nanowire formation. In the first case, the influence of the confinement of the critical nucleus between two parallel misfitting substrates is investigated using scaling arguments. We present phase diagrams giving the nature of the nucleation regime as a function of the driving force and the degree of confinement. We complement this analytical study by amplitude equations simulations. In the second case, the influence of a screw dislocation inside a nanowire on the development of the mor…
Piezoelectric nanowires are promising materials for sensing, actuation and energy harvesting, due to their enhanced properties at the nanoscale. However, quantitative characterization of piezoelectricity in nanomaterials is challenging due to practical limitations and the onset of additional electromechanical phenomena, such as the triboelectric and piezotronic effects. Here, we present an open-circuit conductive atomic force microscopy (cAFM) methodology for quantitative extraction of the axial piezoelectric coefficients of nanowires. We show, both theoretically and experimentally, that the s…
