In this paper, we study single transceiver passive RFID networks by modeling the underlying physical system as a special cascade of a certain broadcast channel (BCC) and a multiple access channel (MAC), using a "nested codebook" structure in between. The particular application differentiates this communication setup from an ordinary cascade of a BCC and a MAC, and requires certain structures such as "nested codebooks", impurity channels or additional power constraints. We investigate this problem both for discrete alphabets, where we characterize the achievable rate region, as well as for continuous alphabets with additive Gaussian noise, where we provide the capacity region. Hence, we establish the maximal achievable error free communication rates for this particular problem which constitutes the fundamental limit that is achievable by any TDMA based RFID protocol and the achievable rate region for any RFID protocol for the case of continuous alphabets under additive Gaussian noise.
This paper discusses a new channel model and code design for the reader-to-tag channel in near-field passive radio frequency identification (RFID) systems using inductive coupling as a power transfer mechanism. If the receiver resynchronizes its internal clock each time a bit is detected, the bit-shift channel used previously in the literature to model the reader-to-tag channel needs to be modified. In particular, we propose a discretized Gaussian shift channel as a new channel model in this scenario. We introduce the concept of quantifiable error avoidance, which is much simpler than error co…
In this paper, we present two practical ARQ-Based security schemes for Wi-Fi and RFID networks. Our proposed schemes enhance the confidentiality and authenticity functions of these networks, respectively. Both schemes build on the same idea; by exploiting the statistical independence between the multipath fading experienced by the legitimate nodes and potential adversaries, secret keys are established and then are continuously updated. The continuous key update property of both schemes makes them capable of defending against all of the passive eavesdropping attacks and most of the currently-kn…
Backscatter wireless communication is an emerging technique widely used in low-cost and low-power wireless systems, especially in passive radio frequency identification (RFID) systems. Recently, the requirement of high data rates, data reliability, and security drives the development of RFID systems, which motivates our investigation on the physical layer security of a multiple-input multiple-output (MIMO) RFID system. In this paper, we propose a noise-injection precoding strategy to safeguard the system security with the resource-constrained nature of the backscatter system taken into conside…
Grouped Annulus-Modulated Transceiver Is Almost Full DoF-Achieving for RIS-Assisted Symbiotic Radios Over Spatial-Correlated Channels
Nanjing University of Information Science and Technology（南京信息工程大学）；Sixty-Third Research Institute, National University of Defense Technology（国防科技大学第六十三研究所）；Naval University of Engineering（海军工程大学）
Transmitter (TX) cooperation at various levels has been shown to increase the sum throughput of multiuser multiple-input multiple-output (MIMO) systems. In this paper we consider a K-user MIMO system where TXs have only global channel state knowledge. It has been theoretically shown that interference alignment (IA) achieves the K/2 degrees of freedom of this K-user MIMO interference channel. However, results on IA and all proposed transceiver techniques for this channel up to date, assume conventional antenna arrays at the transceivers with multiple radio-frequency (RF) chains, each connected …
Xinjiang University（新疆大学）；Dongguan University of Technology（东莞理工学院）；Chongqing University of Posts and Telecommunications（重庆邮电大学）；Tsinghua University（清华大学）；University of Science and Technology Beijing（北京科技大学）
This paper studies achievable information rates of backscatter communication systems where the tag performs load modulation with a freely adaptable passive termination. We find that the complex phasor of the tag current is constrained to a disk and that the capacity problem can therefore be described with existing results on peak-power-limited quadrature channels. This allows us to state the channel capacity and the capacity-achieving distribution of the load impedance, which is described by non-concentric circles in the right half-plane. For the low-SNR case (SNR < 4.8 dB) we find that channe…
In some communication networks, such as passive RFID systems, the energy used to transfer information between a sender and a recipient can be reused for successive communication tasks. In fact, from known results in physics, any system that exchanges information via the transfer of given physical resources, such as radio waves, particles and qubits, can conceivably reuse, at least part, of the received resources. This paper aims at illustrating some of the new challenges that arise in the design of communication networks in which the signals exchanged by the nodes carry both information and en…
In this paper, we consider two fundamental full-duplex (FD) architectures, two-node and three-node, in the context of cellular networks where the terminals employ directional antennas. The simultaneous transmission and reception of data in non-orthogonal channels makes FD radio a potential solution for the currently limited spectrum. However, its implementation generates high levels of interference either in the form of loopback interference (LI) from the output to the input antenna of a transceiver or in the form of co-channel interference in large-scale multicell networks due to the large nu…
We show that nature imposes no fundamental upper limit to the number of information bits per expended photon that can, in principle, be read reliably when classical data is encoded in a medium that can only passively modulate the amplitude and phase of the probe light. We show that with a coherent-state (laser) source, an on-off (amplitude-modulation) pixel encoding, and shot-noise-limited direct detection (an overly-optimistic model for commercial CD/DVD drives), the highest photon information efficiency achievable in principle is about 0.5 bit per transmitted photon. We then show that a cohe…
Key extraction via measuring a physical quantity is a class of information theoretic key exchange protocols that rely on the physical characteristics of the communication channel to enable the computation of a shared key by two (or more) parties that share no prior secret information. The key is supposed to be information theoretically hidden to an eavesdropper. Despite the recent surge of research activity in the area, concrete claims about the security of the protocols typically rely on channel abstractions that are not fully experimentally substantiated. In this work, we propose a novel met…
