Major sterilization mechanisms are related to atoms and radicals, charged parti-cles, excited molecules, ozone, and UV radiation. The ROS (Reactive Oxygen Species) are well known as evildoers. These species are easily created in ambient air and water and they live long enough to reach the cell and attack the organic matter. Test molecules conversion in dry and wet air is studied using Dielectric Barrier Discharge (DBD) and Gliding Arc Reactors (GAR). The effects of tem-perature and energy deposition into the media on the active species production and then on the organic compounds degradation are presented for two non thermal plasma reactors: DBD and GAR. Main production species investigated are OH, O3, NOx, CO and CxHyOz by-products. It is shown from experiment analysis that the reactive species production is quite different from one reactor to another. GAR and pulsed DBD are two chemical processing ways in which the temperature of heavy species in ionized gas is determinant. By reviewing the species production obtained from both reactors, a discussion is open about plasma decontamination.
Hydrogen is largely produced via natural gas reforming or electrochemical water-splitting, leaving organic solid feedstocks under-utilized. Plasma technology powered by renewable electricity can lead to the sustainable upcycling of plastic waste and production of green hydrogen. In this work, low-temperature atmospheric pressure plasma reactors based on transferred arc (transarc) and gliding arc (glidarc) discharges are designed, built, and characterized to produce hydrogen from low-density polyethylene (LDPE) as a model plastic waste. Experimental results show that hydrogen production rate an…
This paper reports on experimental measurements of the gas temperature in a dielectric barrier discharge reactor powered by a high voltage pulsed signal. It is shown that the thermal behavior of the reactor follows a first order model. However, an unexpected runaway phenomenon was observed at a frequency of 300Hz. A sudden increase in the power source and consequently in reactor temperature which reaches 170°C is observed. This behavior is discussed in terms of input power variation with temperature, possibly due to a resonance phenomenon.
Electron temperature for inductively RF post-discharge of pure neon (Ne) with a newly reactor design was presented in comparison for two different methods. Optical emission spectroscopy (OES) was applied for characterizations of inductively RF Ne plasma at pressures between 0.17mbar and 1.4mbar for newly reactor type. Discharge and post-discharge were generated with an RF power supply at a frequency of 13.56MHz and output powers of 100, 160 and 200W. Spectra were evaluated in the range 200-1200nm by an optical spectrometer. At low pressure, the main spectral features reported were the waveleng…
We present a novel microplasma flow reactor using a dielectric barrier discharge (DBD) driven by repetitively nanosecond high-voltage pulses. Our DBD-based geometry can generate a non-thermal plasma discharge at atmospheric pressure and below in a regular pattern of micro-channels. This reactor can work continuously up to about 100 minutes in air, depending on pulse repetition rate and operating pressure. We here present the geometry and the main characteristics of the reactor. Pulse energies of 1.9 $μ$J and 2.7 $μ$J per channel at atmospheric pressure and 50 mbar, respectively, have been dete…
A 13.56 MHz RF discharge in hydrogen was studied within the pressure range of 1-17 10 Pa, and at power range of 400-1000 W. The electron energy distribution function and 18 electron density were measured by a Langmuir probe. The gas temperature was determined by 19 the Fulcher-$α$ system in pure H2, and by the second positive system of nitrogen using N2 as the 20 probing gas. The gas temperature was constant and equal to 450 $\pm$ 50 K in the Capacitively 21 Coupled Plasma mode (CCP), and it was increasing with pressure and power in the Inductively 22 Coupled Plasma mode (ICP). Also the vibrat…
In a DC point-to-plane corona discharge reactor, the mono filamentary streamers cross the inter electrode gap with a natural repetition frequency of some tens of kHz. The discharge phase (including the primary and the secondary streamers development) lasts only some hundred of nanoseconds while the post-discharge phases occurring between two successive discharge phases last some tens of microseconds. From the point of view of chemical activation, the discharge phases create radical and excited species located inside the very thin discharge filaments while during the post-discharge phases these…
Full cycle, self-consistent, two-dimensional analysis of a packed bed DBD reactor for plasma-assisted $\mathrm{CO_{2}}$ splitting: spatiotemporal inhomogeneous, glow to streamer to surface discharge transitions
This paper presents the results of a theoretical and experimental study of plasma-assisted reforming of ethanol into molecular hydrogen in a new modification of the "tornado" type electrical discharge. Numerical modeling clarifies the nature of the non-thermal conversion and explains the kinetic mechanism of nonequilibrium plasma-chemical transformations in the gas-liquid system and the evolution of hydrogen during the reforming as a function of discharge parameters and ethanol-to-water ratio in the mixture. We also propose a scheme of chemical reactions for plasma kinetics description. It is …
The use of dielectric barrier discharge (DBD) plasmas has become a practical way to carry out surface treatment and one seeks to do it in a more efficient way, which requires to have control of the plasma parameters like rotational and vibrational temperatures (T_rot and T_vib). Since the T_vib of an atmospheric pressure plasma jet is an important parameter related to improvement of surface treatments, in this work it was analyzed two methods to increase the values of T_vib in the DBD plasma. One of the methods is to reduce the exit size of the DBD reactor, and the other is to change the gas f…
Proof of operation of a micro-hollow cathode discharge driven by a true ns-pulsed high voltage: emission properties and atomic nitrogen production
Laboratoire des Sciences des Procédés et des Matériaux (LSPM), CNRS, Université Sorbonne Paris Nord（材料过程与科学实验室，法国国家科学研究中心，索邦巴黎北大学）；Laboratoire Energétique Moléculaire et Macroscopique, Combustion (EM2C), CNRS, Université Paris Saclay（分子与宏观能量、燃烧实验室，法国国家科学研究中心，巴黎萨克雷大学）
Packed bed plasma reactors (PBPRs) inherently have complex geometries where the volume between the electrodes is filled with dielectric/catalytic pellets to form an array of voids and cavities. This design generates multiple length scales i.e. the dimension of the plasma region (of the order of centimeters), of the dielectric/catalytic pellets (of the order of millimeters) and of the void between the dielectrics (or cavities) and/or surface pores that can reach micrometer dimensions. The plasma is formed as an array of connected or segmented microdischarges. The understanding of plasma propaga…
Methods for reduction of Volatile Organic Compounds (VOCs) content in air depend on the 10 application considered. For low concentration and low flux, non-thermal plasma methods are often considered as efficient. However, the complex chemistry involved is still not well understood as there is a lack of datasets of byproducts formation. So as to overcome this issue, rapid analytical methods are needed. We present the coupling of a rapid chemical ionization mass spectrometer (CIMS) for the real-time analysis of the VOCs formed during a degradation experiment. The high resolution instrument used …
