We studied complex lasing pattern formations in a thin-slice solid-state laser with wide-aperture laser-diode end-pumping. Radial and rectangular vortex arrays were found to be formed in a controlled fashion with symmetric and asymmetric pump beam profiles, respectively. Most of these vortices exhibited single-frequency oscillations arising from a spontaneous process of transverse mode locking of nearly degenerate modes assisted by the laser nonlinearity. Single-frequency rectangular array beams consisting of a large number of vortices, e.g., closely packed 36 or 46 vortex pixels, were generated, originating from Ince-Gaussian modes excited by the asymmetric pumping.
Broad area laser diodes are attractive for the high optical power they can produce. Unfortunately, this high power normally comes at the cost of severely reduced spatial coherence since the wide area of the semiconductor wave-guide is inherently spatially multi-mode (in the slow axis). We demonstrate a method to majorly improve the spatial coherence of a high-power broad-area diode laser by placing it in an external cavity that is mode selective. We design the cavity, such that the diode aperture acts as its own spatial filter, obviating the need for an intra-cavity slit-filter, and optimally …
Broad aperture semiconductor lasers usually suffer from low spatial quality of the emitted beams. Due to the highly compact character of such lasers the use of a conventional intra-cavity spatial filters is problematic. We demonstrate that extremely compact Photonic Crystal spatial filters, incorporated into the laser resonator, can improve the beam spatial quality, and correspondingly, increase the brightness of the emitted radiation. We report the decrease of the M2 from 47 down to 28 due to Photonic Crystal spatial intra-cavity filtering, and the increase of the brightness by a factor of 1.…
We describe an efficient laser emission from a directly grown Er3+:YAG single-crystal fiber that is resonantly pumped using a continuous-wave (CW) laser diode at 1532 nm. In a longitudinal pumping, it emits 12.5 W at 1645 nm with a slope efficiency of 32%, which is the highest ever reported for a directly grown Er:YAG single-crystal fiber laser. Using an off-axis pumping scheme, CW output powers up to 7.3 W can be reached and in Q-switched operation, the laser produces 2 mJ pulses with a duration of 38 ns at the repetition rate of 1 kHz with an M^{2} factor below 1.8. To our knowledge this is …
We show the abundance of Exceptional Points in the generic asymmetric configuration of two coupled diode lasers, under nonzero optical detuning and differential pumping. We pinpoint the location of these points with respect to the stability domains and the Hopf bifurcation points, in the solution space as well as in the space of experimentally controlled parameters.
We demonstrate yellow laser emission using silicate glass fiber as the gain medium. By employing core pumping using widely available GaN diode lasers with emission at 445 nm, we show that Dy3+-doped aluminosilicate glass fiber can be readily excited creating sufficient gain at 581 nm. In this proof of concept demonstration, the maximum output power generated was 3 mW with a slope efficiency approximately 1.8% with respect to injected pump.
We demonstrated a 967 nm diode end-pumped Er:GSGG laser operated at 2.794 Micrometer with spectrum width 3.6 nm in the continuous wave(CW) mode. The maximum output power of 440 mW is obtained at an incident pumping power of 3.4 W, which corresponds to an optical-to-optical efficiency of 13% and slope efficiency of 13.2%. The results suggest that short cavity and efficient cooling setup for crystal are advantageous to improve laser performance.
Origin of recently discovered reversed (opposite sign) dark resonances was explained theoretically and verified experimentally. It is shown that the reason for these resonances is a specific optical pumping of ground state level in a transition when ground state angular momentum is smaller than the excited state momentum.
An ultra-low intensity and beatnote phase noise dual-frequency vertical-external-cavity surface-emitting laser is built at telecom wavelength. The pump laser is realized by polarization combining two single-mode fibered laser diodes in a single-mode fiber, leading to a 100 % in-phase correlation of the pump noises for the two modes. The relative intensity noise is lower than -140 dB/Hz, and the beatnote phase noise is suppressed by 30 dB, getting close to the spontaneous emission limit. The role of the imperfect cancellation of the thermal effect resulting from unbalanced pumping of the two mo…
The characteristics of mid-infrared laser diodes have been investigated before and after the patterning of sub-wavelength metallic apertures on the emitting facet. Before modification of the facet the emitted spectrum consisted of a large number of peaks associated with different spatial modes, whereas afterwards the spectrum was dominated by a single peak. Simulations showed that the patterning of the facet caused the effective reflectivity to be different for each lateral mode, suggesting that the peak in the measured spectra is associated with the single lateral mode which is most strongly …
Light propagation in asymmetric Kerr-nonlinear multilayers with perfect transmission resonances is theoretically investigated. It is found that hybrid Fabry-Pérot/photonic-crystal structures of the type (BA)^k(AB)^k(AABB)^m exhibit both pronounced unidirectionality (due to strong spatial asymmetry of the resonant mode) and high transmission (due to the existence of a perfect transmission resonance). This results in nonlinear optical diode action with low reflection losses without need for a pumping beam or input pulse modulation. By slightly perturbing the perfect transmission resonance condit…
We describe a compact waveguide amplifier system that is suitable for optically pumping rubidium magnetometers. The system consists of an auto-locking vacuum-sealed external cavity diode laser, a semiconductor tapered amplifier and a pulsing unit based on an acousto-optic modulator. The diode laser utilises optical feedback from an interference filter to narrow the linewidth of an inexpensive laser diode to ~500 kHz. This output is scannable over an 8 GHz range (at 780 nm) and can be locked without human intervention to any spectral marker in an expandable library of reference spectra, using t…
Generation of photon pairs from compact, manufacturable and inexpensive silicon (Si) photonic devices at room temperature may help develop practical applications of quantum photonics. An important characteristic of photon-pair generation is the two-photon joint spectral intensity (JSI), which describes the frequency correlations of the photon pair. In particular, heralded single-photon generation requires uncorrelated photons, rather than the highly anti-correlated photons conventionally obtained under continuous-wave (CW) pumping. Recent attempts to achieve such a factorizable JSI have used s…
A simple and high-efficiency method for direct generation of all-solid-state single- and dual-vortex lasers operating at eye-safe wavelengths is reported in a compact diode-end-pumped Nd:YAG laser cavity. By off-axis pumping of the Nd:YAG in two orthogonal directions, the original cavity mode, fundamental Gaussian mode (TEM00), is directly transformed into first-order Laguerre-Gaussian (LG01) mode with single- or dual-vortex structures depending on the degree of the off-axis pumping. Moreover, the single- and dual-vortex lasers can be produced in simultaneous eye-safe dual-wavelength operation…
A new electron beam-optical procedure is proposed for quasi-cw pumping of high-pressure large-volume He-Ar laser on 4p[1/2]1 - 4s[3/2]2 argon atom transition at the wavelength of 912.5 nm. It consists of creation and maintenance of a necessary density of 4s[3/2]2 metastable state in the gain medium by a fast electron beam and subsequent optically pumping of the upper laser level via the classical three-level scheme using a laser diode. Absorption probing is used to study collisional quenching of Ar* metastable in electron-beam-excited high-pressure He-Ar mixtures with a low content of argon. T…
Soliton microcombs offer the prospect of advanced optical metrology and timing systems in compact form factors. In these applications, pumping of microcombs directly from a semiconductor laser without amplification or triggering components is desirable for reduced power operation and to simplify system design. At the same time, low repetition rate microcombs are required in many comb applications for interface to detectors and electronics, but their increased mode volume makes them challenging to pump at low power. Here, 10 GHz repetition rate soliton microcombs are directly pumped by low-powe…
The two-photon transition $5S-5P-5D$ in rubidium vapor is investigated by detecting the fluorescence from the $6P_{3/2}$ state when the atomic system is excited by the combined action of a cw diode laser and a train of ultrashort pulses. The cw-laser plays a role as a velocity-selective filter and allows for a spectroscopy over a large spectral range including the $5D_{3/2}$ and $5D_{5/2}$ states. For a counterpropagating beam configuration, the response of each atomic velocity group is well characterized within the Doppler profile, and the excited hyperfine levels are clearly resolved. The co…
We report a fully-correlated multi-mode pumping architecture optimized for dramatic noise reduction of a class-A dual-frequency Vertical External Cavity Surface Emitting Laser (VECSEL). Thanks to amplitude division of a laser diode, the two orthogonally polarized modes emitted by the VECSEL oscillating at 852 nm are separately pumped by two beams exhibiting fully in--phase correlated intensity noises. This is shown to lead to very strong and in-phase correlations between the two lasing modes intensities. As a result, the phase noise power spectral density of the RF beat note generated by the t…
We experimentally demonstrate spatial beam self-cleaning in an Yb-doped graded-index multimode fiber taper, both in passive and active configurations. The input laser beam at 1064 nm was injected for propagation from the small to the large core side of the taper, with laser diode pumping in a counterdirectional configuration. The Kerr effect permits to obtain high-beam quality amplification with no accompanying frequency conversions. As a result, our nonlinear taper amplifier may provide an important building block for multimode fiber lasers and amplifiers.
We demonstrate high-energy terahertz generation from a large-aperture (75 mm diameter) lithium niobate wafer by using a femtosecond laser with energy up to 2 J. This scheme utilizes optical rectification in a bulk lithium niobate crystal, where most terahertz energy is emitted from a thin layer of the rear surface. Despite its simple setup, this scheme can yield 0.19 mJ of terahertz energy with laser-to-terahertz conversion efficiencies of ~0.01%, about 3 times better than ZnTe when pumped at 800 nm. The experimental setup is up-scalable for multi-mJ terahertz generation with petawatt laser pu…
Organic solid-state lasers are reviewed, with a special emphasis on works published during the last decade. Referring originally to dyes in solid-state polymeric matrices, organic lasers also include the rich family of organic semiconductors, paced by the rapid development of organic light emitting diodes. Organic lasers are broadly tunable coherent sources are potentially compact, convenient and manufactured at low-costs. In this review, we describe the basic photophysics of the materials used as gain media in organic lasers with a specific look at the distinctive feature of dyes and semicond…
The amplitude and phase noises of a dual-frequency vertical-external-cavity surface-emitting laser (DF-VECSEL) operating at telecom wavelength are theoretically and experimentally investigated in detail. In particular, the spectral behavior of the correlation between the intensity noises of the two modes of the DF-VECSEL is measured. Moreover, the correlation between the phase noise of the radio-frequency (RF) beatnote generated by optical mixing of the two laser modes with the intensity noises of the two modes is investigated. All these spectral behaviors of noise correlations are analyzed fo…
Relaxing Coherence Requirements on Laser Sources for Nanoscopy through Optical Fiber Technique
Max Planck Institute for Polymer Research（马克斯·普朗克聚合物研究所）；School of Electrical and Information Engineering, Anhui University of Science and Technology（安徽理工大学电气与信息工程学院）；Institute of Molecular Biology (IMB)（分子生物学研究所）；Institute of Fiber Optics, The Key Laboratory of Specialty Fiber Optics and Optical Access Network, Shanghai University（上海大学光纤技术研究所特种光纤与光接入网络重点实验室）；State Key Laboratory of Satellite Network, Shanghai Key Laboratory of Satellite Network, Shanghai Satellite Network Research Institute Co., Ltd（上海卫星网络研究所有限公司卫星网络国家重点实验室卫星网络上海市重点实验室）；Department of Electrical and Photonics Engineering, Technical University of Denmark（丹麦技术大学电气与光子工程系）
