arXivDaily arXiv每日学术速递 周一至周五更新
arXiv 0711.3286cs.OH
收藏

RF溅射法制备的ZNO基SI薄膜的退火诱导反常性能

The annealing induced extraordinary properties of SI based ZNO film grown by RF sputtering

Jing Li, L. Dedeng, Suntao Wu

摘要:

采用脉冲激光沉积(PLD)技术,在Pt/Ti/SiO2/Si衬底上原位沉积了Pb(Zr0.52Ti0.48)O3(PZT)薄膜。首先采用溶胶-凝胶法在Pt/Ti/SiO2/Si衬底上沉积了厚度为0.1 m、具有(111)或(100)择优取向的$μ$层,然后通过PLD在上述PZT层上原位沉积了厚度为1 m的$μ$层。通过X射线衍射分析研究了PZT薄膜的晶相和择优取向。用扫描电子显微镜和透射电子显微镜观察表面和截面形貌。通过测量薄膜的P-E磁滞回线和介电常数来评价薄膜的电学性能。利用溶胶-凝胶法制备的模板层可以控制薄膜的择优取向。在该方法中,获得钙钛矿相所需的沉积温度约为460 ℃,并且显著低于在Pt/Ti/SiO2/Si衬底上通过PLD直接膜沉积的情况。关键词:锆钛酸铅(PZT),薄膜,溶胶-凝胶法,激光烧蚀,电学性能

英文摘要:

Pb(Zr0.52Ti0.48)O3 (PZT) thin films were in situ deposited by pulsed laser deposition (PLD) on Pt/Ti/SiO2/Si substrates using a template layer derived by sol-gel method. A 0.1-$μ$m-thick PZT layer with (111) or (100)-preferred orientation was first deposited onto Pt/Ti/SiO2/Si substrates using the sol-gel method, and than a PZT layer with thickness of 1$μ$m was in situ deposited by PLD on the above-mentioned PZT layer. The crystalline phases and the preferred orientations of the PZT films were investigated by X-ray diffraction analysis. Surface and cross-sectional morphologies were observed by scanning electron microscopy and transmission electron microscopy. The electrical properties of the films were evaluated by measuring their P-E hysteresis loops and dielectric constants. The preferred orientation of the films can be controlled using the template layer derived by the sol-gel method. The deposition temperature required to obtain the perovskite phase in this process is approximately 460 degrees C, and is significantly lower than that in the case of direct film deposition by PLD on the Pt/Ti/SiO2/Si substrates. Keywords: lead zirconate titanate (PZT), thin film, sol-gel method, laser ablation, electrical properties

机构、总结、中文摘要均由AI分析而来,可能存在错误,请以论文正文为准。

↑